The following codes can be returned:
Code Description
0x0000 No error
0x80D0 Channel 0 not in status active
0x80D1 Channel 1 not in status active
0x80D6 Channel 0: Input value RESOLUTION_CH0 = 0
0x80D7 Channel 1: Input value RESOLUTION_CH1 = 0
0x80D8 Channel 0: Input value RESOLUTION_CH0 < 0
0x80D9 Channel 1: Input value RESOLUTION_CH1 < 0
0x80DA Channel 0: Measured time value = 0
0x80DB Channel 1: Measured time value = 0
0x80DC Channel 0: Measured time value < 0
0x80DD Channel 1: Measured time value < 0
0x80DE Channel 0: Measured time value > 0x7FFFFFF
0x80DF Channel 1: Measured time value > 0x7FFFFFF
0x80E2 Channel 0: Determined number of edges < 0
0x80E3 Channel 1: Determined number of edges < 0
0x80E4 Channel 0: Determined number of edges > 0xFFFFFF
0x80E5 Channel 1: Determined number of edges > 0xFFFFFF
0x80E6 Channel 0: Determined rotational speed > max. (DINT)
0x80E7 Channel 1: Determined rotational speed > max. (DINT)
0x80E8 Channel 0: No valid measurement within the entered measurement period
0x80E9 Channel 1: No valid measurement within the entered measurement period
Code Description
0x808x System error on the bus coupler
0x8090 LADDR_IN is not correct, possible reasons:
n there is no module configured on this address
n limitation of the length of consistent data
was not considered
n Basic address in parameter LADDR_IN
was not entered in hexadecimal type
0x8093 There is no bus coupler existing for LADDR_IN, to which consistent data
can be written.
0x80A0 An access error was detected during peripheral access.
0x80B0 System error on the bus coupler
0x80B1 Specified length of the source area does not correspond to the config-
ured user data length.
ERROR (Return value)
Error of the internal called
SFC 14
VIPA SPEED7
Device Specific
Frequency Measurement > FC 303 - FM_GET_SPEED - Calculate rotational speed consistent
HB00 | OPL_SP7 | Operation list | en | 18-30 255
To Next Page
Loading...
