UDT - Header Declaration Data type Description
Status_Global OUTPUT BYTE Block status
n 0x00: Not processed
n 0x01: In process (BUSY)
n 0x02: Ready without error (DONE)
n 0x80: Error on processing (ERROR)
Status
Alarm_Global
OUTPUT BYTE Corresponds to B3: Header byte 3 - Common status
n Bit 0: Frequency F_MAX exceeded
n Bit 1: Frequency F_MIN undershot
n Bit 2: Temperature T_MAX exceeded
n Bit 3: Voltage VRMS_MAX exceeded
n Bit 4: Voltage VRMS_MIN undershot
n Bit 5: Efficiency PF_MIN undershot
n Bit 6: Current IRMS_MAX exceeded
n Bit 7: reserved
Cmd INPUT BYTE 0: de-activated, 1: activated
n Bit 0: Reset all the energy counters
n Bit 1: Trigger reset on the current transformer
n Bit 2: Reset status measurement
n Bit 3: Writing the energy setpoints from "SetValues" to the ID3 ... ID8.
If several bits are set, they are sequentially processed.
Note: Writing of energy set points requires a protocol version major ³ 1 and
minor ³ 1!
Status_Cmd OUTPUT BYTE Status command
n 0x00: Not processed
n 0x01: In process (BUSY)
n 0x02: Ready without error (DONE)
n 0x80: Error on processing (ERROR) - see ERROR_ID
Jobtime OUTPUT TIME
n Duration to read the measured values respectively to run a command.
DsID OUTPUT BYTE Number of the current DS-ID
Ä
‘DS-ID’ page 265
Frame_ID OUTPUT BYTE Number of the current FR-ID
Ä
‘FR-ID’ page 265
Error_ID OUTPUT WORD Detailed error information
Status_ReadVersion OUTPUT BYTE Status Read FW Version
n 0x00 = never executed
n 0x01: Busy
n 0x02: Done
n 0x80: Error
Reserved STATIC ARRAY of
BYTE
(1...15)
reserved
VersionInfo
Struct The firmware version is determined automatically
FirmwareMajor OUTPUT Byte Firmware version: Major
FirmwareMinor OUTPUT Byte Firmware version: Minor
FirmwareRevision OUTPUT Byte Firmware revision
VIPA SPEED7
Device Specific
Energy Measurement > UDT 325 - EM_DATA_R1 - Data structure for FB 325
HB00 | OPL_SP7 | Operation list | en | 18-30 269
To Next Page
Loading...
