1.
In your project, click at ‘Blocks’ and choose ‘Context menu è Insert new object
è Data block’.
Specify the following parameters:
n Name and type
– The DB no. as ‘Name’ can freely be chosen, such as DB 10.
– Set ‘Shared DB’ as the ‘Type’ .
n Symbolic name
– Specify "Axis01".
Confirm your input with [OK].
ð
The block is created.
2. Open DB 10 "Axis01" by double-click.
n In "Axis01", create the variable "Config" of type UDT 870. These are specific
axis configuration data.
n In "Axis01", create the variable "Axis" of type UDT 860. During operation, all
operating data of the axis are stored here.
Create axis DB
VIPA SPEED7
Motion control - Simple Motion Control Library
Usage Sigma-5/7 EtherCAT > Usage Sigma-5 EtherCAT
HB00 | OPL_SP7 | Operation list | en | 18-30 317
To Next Page
Loading...
