1. Click in the Project tree at ‘Devices and networking’ .
ð
You will get a graphical object view of your CPU.
2. Click at the network ‘PG_OP_Ethernet’ .
3.
Select ‘Context menu è Interface properties’.
ð
A dialog window opens. Here you can enter the IP address data for your
Ethernet PG/OP channel. You get valid IP address parameters from your
system administrator.
4. Confirm with [OK].
ð
The IP address data are stored in your project listed in ‘Devices and
networking’ at ‘Local components’ .
After transferring your project your CPU can be accessed via Ethernet PG/OP
channel with the set IP address data.
For parametrization of the I/O periphery and the technological functions the corre-
sponding sub modules of the CPU are to be used. For PWM output, the sub module
count must be switched to ‘Pulse-width modulation’ .
1. Click in the Project tree at ‘PLC... > Device configuration’ .
2. Click in the ‘Device configuration’ at ‘-X27 Count’ and select ‘Context menu
è Components properties’.
ð
The properties dialog is opened.
3. For example, select ‘channel 0’ and select the function ‘Pulse-width modulation’ as
‘Operating mode’ .
Configuration of Ethernet
PG/OP channel
Switch I/O periphery to
PWM
VIPA SPEED7
Motion control - Simple Motion Control Library
Usage inverter drive via PWM > Usage in VIPA SPEED7 Studio
HB00 | OPL_SP7 | Operation list | en | 18-30 435
To Next Page
Loading...
