YASKAWA VIPA SPEED7 - Page 643

ErrorID Description Remark
0x871C SDO error: The number and length of objects to be mapped
exceeds the PDO length.
0x871D SDO error: General parameter incompatibility.
0x871E SDO error: General internal incompatibility in the device.
0x871F SDO error: Access failed due to a hardware error.
0x8720 SDO error: Data type does not match, length of service parameter
does not match.
0x8721 SDO error: Data type does not match, service parameter too long.
0x8722 SDO error: Data type does not match, service parameter too short.
0x8723 SDO error: There is no subindex.
0x8724 SDO error: Write access - Parameter value out of range.
0x8725 SDO error: Write access - Parameter value out of high limit
0x8726 SDO error: Write access - Parameter value out of low limit.
0x8727 SDO error: Maximum value < Minimum value.
0x8728 SDO error: General error.
0x8729 SDO error: Unable to transfer or store data to application.
0x872A SDO error: Unable to transfer or store data to application because
of local.
0x872B SDO error: Unable to transfer or store data to application because
of present device state.
0x872C SDO error: The dynamic generation of the object dictionary failed or
missing object dictionary.
0x872D SDO error: Unknown code.
0x8750 Wrong value in LADDR.
0x8751 Type other than BYTE in ANY pointer.
0x8752 There is no PROFIBUS DP module or PROFINET IO device on the
address, specified via LADDR, from which consistent data can be
read.
0x8753 Access error when accessing a PROFINET IO device.
0x8754 Slave error on the external PROFIBUS DP slave.
0x8755 Length of the SFB data does not match the length of the user data.
0x8756 Error on external PROFIBUS DP slave.
0x8757 System error on external PROFIBUS DP slave.
0x8758 The data has not yet been read by the device.
0x8759 System error on external PROFIBUS DP slave.
0x875A No system resources are available.
0x8799 SDO error: An other error appeared, for more information, see the
data of Info1 and Info2.
0x8888 Internal: BufferIndex error VMC_AxisControl
VIPA SPEED7
Motion control - Simple Motion Control Library
ErrorID - Additional error information
HB00 | OPL_SP7 | Operation list | en | 18-30 643