3Com 5500-EI PWR - System Status and Information Display Commands; Display Clock; Display Debugging

1-6
System Status and Information Display Commands
display clock
Syntax
display clock
View
Any view
Parameters
None
Description
Use the display clock command to display the current date, time, timezone and summertime of the
system, so that you can adjust them if they are wrong.
The maximum date and time that can be displayed by this command is 23:59:59 9999/12/31.
Related commands: clock datetime, clock timezone, clock summer-time.
Examples
# Display the current date and time of the system.
<Sysname> display clock
18:36:31 beijing Sat 2002/02/02
Time Zone : beijing add 01:00:00
Summer-Time : bj one-off 01:00:00 2003/01/01 01:00:00 2003/08/08 01:00:00
Table 1-1 Description on the fields of the display clock command
Field Description
18:36:31 beijing Sat 2002/02/02 Current date and time of the system
Time Zone Configured time zone information
Summer-Time Configured summer time information
display debugging
Syntax
display debugging [ unit unit-id ] [ interface interface-type interface-number ] [ module-name ]
display debugging fabric [ by-module | interface interface-type interface-number [ module-name ] |
module-name ]
View
Any view
Parameters
unit-id: Unit ID of a switch.