3Com 5500-EI PWR - Access Management Configuration Commands

1-1
1 Access Management Configuration Commands
Access Management Configuration Commands
am enable
Syntax
am enable
undo am enable
View
System view
Parameters
None
Description
Use the am enable command to enable the access management function.
Use the undo am enable command to disable the function.
By default, Access management function is disabled.
Before enabling access management, you are recommended to cancel the static ARP
configuration to ensure that the binding of IP address and Ethernet switch can take effect.
Examples
# Enable the access management function.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] am enable
am ip-pool
Syntax
am ip-pool address-list
undo am ip-pool { all | address-list }