3Com 5500-EI PWR - Register-Policy; Reset Pim Neighbor

3-15
Examples
# Set the PIM prune delay interval to 75 seconds.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] pim
[Sysname-pim] prune delay 75
register-policy
Syntax
register-policy acl-number
undo register-policy
View
PIM view
Parameters
acl-number: Number of IP advanced ACL that defines the rule for filtering the source and group
addresses. The value ranges from 3000 to 3999. Only register messages that match the permit
statement can be accepted by the RP.
Description
Use the register-policy command to configure a rule for filtering register messages.
Use the undo register-policy command to remove a rule for filtering register messages.
By default, no rule for filtering register messages is configured.
Examples
# Configure a rule for filtering register messages on the RP to allow multicast sources in the range of
10.10.0.0/16 to send multicast data to multicast groups in the range of 225.1.0.0/16.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] acl number 3010
[Sysname-acl-adv-3010] rule permit ip source 10.10.0.0 0.0.255.255 destination 225.1.0.0
0.0.255.255
[Sysname-acl-adv-3010] quit
[Sysname] pim
[Sysname-pim] register-policy 3010
reset pim neighbor
Syntax
reset pim neighbor { all | { neighbor-address | interface interface-type interface-number } * }
View
User view