3Com 5500-EI PWR - Display Hwtacacs

1-61
Note that the specified unit of data flows sent to the TACACS server must be consistent with the
traffic statistics unit of the TACACS server. Otherwise, accounting cannot be performed correctly.
Related commands: display hwtacacs.
Examples
# Specify to measure data and packets in data flows to TACACS servers in kilo-bytes and
kilo-packets respectively in HWTACACS scheme hwt1.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] hwtacacs scheme hwt1
[Sysname- hwtacacs-hwt1] data-flow-format data kilo-byte
[Sysname- hwtacacs-hwt1] data-flow-format packet kilo-packet
display hwtacacs
Syntax
display hwtacacs [ hwtacacs-scheme-name [ statistics ] ]
View
Any view
Parameters
hwtacacs-scheme-name: HWTACACS scheme name, a string of 1 to 32 characters. This name is
case-insensitive. If this argument is not specified, the system displays information about all
HWTACACS schemes.
statistics: Displays statistics about one or all HWTACACS schemes.
Description
Use the display hwtacacs command to display configuration or statistics information of one
specified or all HWTACACS schemes.
Related commands: hwtacacs scheme.
Examples
# Display configuration information of HWTACACS scheme ht1.
<Sysname> display hwtacacs ht1
-------------------------------------------------------------------- HWTACACS-server
template name : ht1
Primary-authentication-server : 172.31.1.11:49
Primary-authorization-server : 172.31.1.11:49
Primary-accounting-server : 172.31.1.11:49
Secondary-authentication-server : 0.0.0.0:0
Secondary-authorization-server : 0.0.0.0:0
Secondary-accounting-server : 0.0.0.0:0