3Com 5500-EI PWR - Port-Security Ntk-Mode

1-12
By default, there is no limit on the number of MAC addresses allowed on the port.
By configuring the maximum number of MAC addresses allowed on a port, you can:
z Limit the number of users accessing the network through the port.
z Limit the number of security MAC addresses that can be added on the port.
When the maximum number of MAC addresses allowed on a port is reached, the port will not allow
more users to access the network through this port.
z The port-security max-mac-count command is irrelevant to the maximum number of MAC
addresses that can be learned on a port configured in MAC address management.
z When there are online users on a port, you cannot perform the port-security max-mac-count
command on the port.
Examples
# Set the maximum number of MAC addresses allowed on the port to 100.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] port-security enable
[Sysname] interface Ethernet 1/0/1
[Sysname-Ethernet1/0/1] port-security max-mac-count 100
port-security ntk-mode
Syntax
port-security ntk-mode { ntkonly | ntk-withbroadcasts | ntk-withmulticasts }
undo port-security ntk-mode
View
Ethernet port view
Parameters
ntkonly: Allows the port to transmit only unicast packets with successfully-authenticated destination
MAC addresses.
ntk-withbroadcasts: Allows the port to transmit broadcast packets and unicast packets with
successfully-authenticated destination MAC addresses.
ntk-withmulticasts: Allows the port to transmit multicast packets, broadcast packets and unicast
packets with successfully-authenticated destination MAC addresses.