3Com 5500-EI PWR - Speed; Speed Auto

1-32
Vlan-interface3 is UP
%Apr 13 23:14:54:897 2000 Sysname IFNET/5/UPDOWN:- 1 -Line protocol on the interface
Vlan-interface3 is UP
speed
Syntax
speed { 10 | 100 | 1000 | auto }
undo speed
View
Ethernet port view
Parameters
10: Specifies the port speed to 10 Mbps.
100: Specifies the port speed to 100 Mbps.
1000: Specifies the port speed to 1,000 Mbps (only available to GigabitEthernet ports).
auto: Specifies the port speed to the auto-negotiation mode.
Description
Use the speed command to set the port speed.
Use the undo speed command to restore the port speed to the default setting.
By default, the port speed is in the auto-negotiation mode.
Note that you can only specify the 1000 and auto keyword for Gigabit Ethernet ports.
Related commands: duplex.
Examples
# Set the speed of Ethernet 1/0/1 to 10 Mbps.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] interface ethernet 1/0/1
[Sysname-Ethernet1/0/1] speed 10
speed auto
Syntax
speed auto [ 10 | 100 | 1000 ]*