3Com 5500-EI PWR - Display Smart-Link Group

1-2
A legal flush message refers to the message whose control VLAN ID is consistent with the receiving
control VLAN ID configured on the receiving port.
display smart-link group
Syntax
display smart-link group { group-id | all }
View
Any view
Parameters
group-id: Smart link group ID, in the range of 1 to 24.
all: Displays the information about all smart link groups.
Description
Use the display smart-link group command to display the information about the specific smart link
group or all the smart link groups.
Examples
# Display the information about smart link group 1.
<Sysname> display smart-link group 1
Smart Link Group 1 information:
Device ID: 000f-e212-3456 Control-VLAN ID: 1
Member Role State Flush-count Last-flush-time
--------------------------------------------------------------------------
Ethernet1/0/1 MASTER ACTVIE 1 16:37:20 2006/04/21
AGG-1 SLAVE STANDBY 2 17:45:20 2006/04/21
Table 1-2 Description on the fields of the display smart-link group command
Field Description
Member Member of the smart link group
Role Port role of a smart link group member: master or slave.
Status
Port status of a smart link group member when the link of this
member port is up: active or standby.
Flush-count Number of sent flush messages
Last-flush-time
Time when the last flush message is sent. If no flush message is
sent, “NA” will be displayed.