3Com 5500-EI PWR - Igmp Proxy

2-10
View
Interface view
Parameters
seconds: Maximum response time in seconds in the IGMP general query messages, ranging from 1 to
25.
Description
Use the igmp max-response-time command to configure the maximum response time carried in the
IGMP general query messages.
Use the undo igmp max-response-time command to restore the default.
The maximum response time is 10 seconds by default.
Related commands: display igmp interface.
Examples
# On VLAN-interface 10, configure the maximum response time carried in IGMP general query
messages to 8 seconds.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] interface Vlan-interface 10
[Sysname-Vlan-interface10] igmp max-response-time 8
igmp proxy
Syntax
igmp proxy interface-type interface-number
undo igmp proxy
View
Interface view
Parameters
interface-type interface-number: Specifies the interface for which the current interface will act as the
IGMP proxy interface.
Description
Use the igmp proxy command to configure the current interface as the IGMP proxy interface for
another interface on the Layer 3 switch.
Use the undo igmp proxy command to restore the default.
No interface is configured as the IGMP proxy interface for another.
Before configuring the igmp proxy command on an interface, you must enable PIM on it. One interface
cannot serve as the IGMP proxy interface for two or more interfaces.
If the IGMP proxy feature is configured repeatedly on the same interface, the last configuration takes
effect.