3Com 5500-EI PWR - Display Transceiver Diagnosis Interface

3-9
Field Remarks
Transceiver info I/O error Transceiver information read and write error
Transceiver info checksum error Transceiver information checksum error
Transceiver type and port configuration
mismatch
Transceiver type does not match port configuration.
Transceiver type not supported by port
hardware
Transceiver type is not supported on the port.
Examples
# Display the alarm information of the transceiver on interface GigabitEthernet 1/0/25.
<Sysname> display transceiver alarm interface gigabitethernet 1/0/25
GigabitEthernet1/0/25 transceiver current alarm information:
TX fault
Table 3-6 Description on the fields of display transceiver alarm interface
Field Description
transceiver current alarm information Current alarm information of the transceiver
TX fault TX fault
display transceiver diagnosis interface
Syntax
display transceiver diagnosis interface [ interface-type interface-number ]
View
Any view
Parameters
interface-type interface-number: Interface type and interface number.
Description
Use the display transceiver diagnosis interface command to display the currently measured value of
digital diagnosis parameters of a single or all anti-spoofing transceivers customized by H3C.
Examples
# Display the currently measured value of digital diagnosis parameters of the anti-spoofing pluggable
optical transceiver customized by H3C on interface GigabitEthernet 1/0/25.
<Sysname> display transceiver diagnosis interface gigabitethernet 1/0/25
GigabitEthernet1/0/25 transceiver diagnostic information:
Current diagnostic parameters:
Temp(°C) Voltage(V) Bias(mA) RX power(dBM) TX power(dBM)
36 3.31 6.13 -35.64 -5.19