3Com 5500-EI PWR - Display Schedule Reboot; Display Transceiver Alarm Interface

3-6
Parameters
unit-id: Unit ID of a switch.
power-id: Power ID.
Description
Use the display power command to display the working state of the power supply of the switch.
Examples
# Display the working state of the power supply.
<Sysname> display power
Unit 1
power 1
State : Normal
Type : AC
The above information indicates that the power supply type is AC, and works normally.
display schedule reboot
Syntax
display schedule reboot
View
Any view
Parameters
None
Description
Use the display schedule reboot command to display information about scheduled reboot.
Related commands: schedule reboot at, schedule reboot delay.
Examples
# Display the information about scheduled reboot.
<Sysname> display schedule reboot
System will reboot at 16:00:00 2002/11/1 (in 2 hours and 5 minutes).
display transceiver alarm interface
Syntax
display transceiver alarm interface [ interface-type interface-number ]
View
Any view
Parameters
interface-type interface-number: Interface type and interface number.