1-3
Field Description
Delay Time Preemption delay
Auth Type Authentication type, including NONE, SIMPLE, and MD5
Virtual IP Virtual IP address of the VRRP group
Virtual MAC
Virtual MAC address corresponding to the virtual IP address of the
VRRP group. It is displayed only when the switch is in the state of
master.
Master IP
Primary IP address of the master’s interface where the VRRP group
is configured.
display vrrp statistics
Syntax
display vrrp statistics [ interface vlan-interface vlan-id [ vrid virtual-router-id ] ]
View
Any view
Parameters
vlan-interface vlan-id: Specifies a VLAN interface by its VLAN ID. vlan-id is the ID of the VLAN
interface.
vrid virtual-router-id: Specifies a VRRP group. virtual-router-id is the VRRP group ID, ranging from 1 to
255.
Description
Use the display vrrp statistics command to display the VRRP statistics information of VRRP group(s).
Refer to Table 1-3 for the displayed information.
z If neither a VLAN interface nor a VRRP group is specified, the statistics information about all the
VRRP groups on the switch is displayed.
z If only a VLAN interface is specified, the statistics information about all the VRRP groups on the
specified VLAN interface is displayed.
z If both a VLAN interface and a VRRP group are specified, the statistics information about the
specified VRRP group on the specified VLAN interface is displayed.
You can clear the VRRP statistics by using the reset vrrp statistics command.
Related commands: reset vrrp statistics
Examples
# Display the VRRP statistics information about all the VRRP groups.
<Sysname> display vrrp statistics
Interface : Vlan-interface1
VRID : 1
CheckSum Errors : 0 Version Errors : 0
VRID Errors : 0 Advertisement Interval Errors : 0
IP TTL Errors : 0 Auth Failures : 0
To Next Page
Loading...
