1-4
Test Type Code Range Default value
UDP None 4-8100 100
Other None 4-8100 0
Description
Use the datasize command to configure the size of a test packet in a test.
Use the undo datasize command to restore the default.
The configuration of packet size is only supported by ICMP, UDP and jitter tests.
Examples
# Set the size of ICMP test packets to 50 bytes.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] remote-ping administrator icmp
[Sysname-remote-ping-administrator-icmp] test-type icmp
[Sysname-remote-ping-administrator-icmp] datasize 50
description
Syntax
description string
undo description
View
remote-ping test group view
Parameters
string: Brief description about a test operation. By default, no description is configured.
Description
Use the description command to briefly describe a test operation.
Use the undo description command to delete the configured description.
Examples
# Describe a test group as “icmp-test”.
<Sysname> system-view
System View: return to User View with Ctrl+Z
[Sysname] remote-ping administrator icmp
[Sysname-remote-ping-administrator-icmp] description icmp-test
destination-ip
Syntax
destination-ip ip-address
To Next Page
Loading...
