3Com 5500-EI PWR - Display Telnet Source-Ip; Display User-Interface

1-6
Examples
# Display the source IP address configured for the switch operating as the Telnet server.
<Sysname> display telnet-server source-ip
The source IP you specified is 192.168.1.1
display telnet source-ip
Syntax
display telnet source-ip
View
Any view
Parameters
None
Description
Use the display telnet source-ip command to display the source IP address configured for the switch
operating as the Telnet client. That is, the source IP address of the Telnet service packets sent when the
switch operates as the Telnet client to log in to the remote device.
z If the source interface is specified for the switch, this command displays the IP address of the
source interface.
z If no source address or source IP interface is specified for the switch, 0.0.0.0 is displayed. That is,
the source IP address of Telnet service packets is that of the outbound interface.
Examples
# Display the source IP address configured for the switch operating as the Telnet client.
<Sysname> display telnet source-ip
The source IP you specified is 192.168.1.1
display user-interface
Syntax
display user-interface [ type number | number ] [ summary ]
View
Any view
Parameters
type: User interface type, which can be AUX (for AUX user interface) and VTY (for VTY user interface).
number: User interface index. A user interface index can be relative or absolute.
z In relative user interface number scheme, the type argument is required. In this case, AUX user
interfaces are numbered from AUX0 through AUX7; VTY user interfaces are numbered from VTY0
through VTY4.