3Com 5500-EI PWR - Display Saved-Configuration

1-6
return
display saved-configuration
Syntax
display saved-configuration [ unit unit-id ] [ by-linenum ]
View
Any view
Parameters
unit unit-id: Specifies the unit ID of a switch. With this keyword-argument combination specified, this
command can display the initial configuration file of the specified unit.
by-linenum: Displays configuration information with line numbers.
Description
Use the display saved-configuration command to display the initial configuration file of a switch.
Note that:
z If the switch starts up without a configuration file, the system will display that no configuration file
exists upon execution of the command.
z If you have saved configuration after the switch starts up, the command displays the last saved
configuration.
Related commands: save, reset saved-configuration, display current-configuration.
Examples
# Display the initial configuration file of the current switch.
<Sysname> display saved-configuration
#
sysname sysname
#
password-control login-attempt 3 exceed lock-time 120
#
radius scheme system
#
domain system
#
vlan 1
#
interface Vlan-interface1
ip address 192.168.0.30 255.255.255.0
#LOCCFG. MUST NOT DELETE
#
ntp-service unicast-server 192.168.0.52
ntp-service unicast-server 192.168.0.65
#
interface Aux1/0/0
#