3Com 5500-EI PWR - 6 Route Capacity Configuration Commands; Display Memory

6-1
6 Route Capacity Configuration Commands
The term router in this chapter refers to a router in a generic sense or an Ethernet switch running a
routing protocol.
Route Capacity Configuration Commands
display memory
Syntax
display memory [ unit unit-id ]
Mode
Any view
Parameters
unit-id: Unit ID.
Description
Use the display memory command to display the memory usage.
Examples
# Display the current memory usage of the switch.
<Sysname> display memory
Unit 1
System Available Memory(bytes): 33631488
System Used Memory(bytes): 16122304
Used Rate: 47%
The following table describes the fields of the command: