1-4
Copying speed/duplex configuration...
z Any aggregation group port you input in the destination port list will be removed from the list and the
copy command will not take effect on the port. If you want an aggregation group port to have the
same configuration with the source port, you can specify the aggregation group of the port as the
destination (with the destination-agg-id argument).
z Any voice-VLAN-enabled port you input in the destination port list will be removed from the list.
# Copy the configurations of Ethernet 1/0/1 to Ethernet 1/0/2.
[Sysname]copy configuration source e1/0/1 destination e1/0/2
Copying VLAN configuration...
Copying Protocol based VLAN configuration...
Copying LACP configuration...
Copying QOS configuration...
Copying GARP configuration...
Copying STP configuration...
Copying speed/duplex configuration...
Copying speed configuration to interface Ethernet1/0/1 failed
Copying QoS rate limit configuration to interface Ethernet1/0/2 failed
The output shows that all configurations except port rate limiting and QoS traffic policing were copied
successfully.
description
Syntax
description text
undo description
View
Ethernet port view
Parameters
text: Port description, a string of 1 to 80 characters. Currently, the switch support the following types of
characters or symbols: standard English characters (numbers and case-sensitive letters), special
English characters, spaces, and other characters or symbols that conform to the Unicode standard,
such as Chinese, Korean, and Japanese. Note that, each character or symbol conforming to the
Unicode standard takes the space of two regular characters.
To Next Page
Loading...
