1-8
Ethernet1/0/1: mirrored-to
Inbound:
Matches: Acl 2000 rule 0 running
Mirrored to: monitor interface
Refer to Table 1-3 for the description on the output fields.
display qos-interface traffic-limit
Syntax
display qos-interface { interface-type interface-number | unit-id } traffic-limit
View
Any view
Parameters
interface-type interface-number: Specifies the type and number of a port for which traffic
policing configuration is to be displayed.
unit-id: Unit ID of the switch whose traffic policing configuration is to be displayed. For the
value range for the unit-id argument, refer to
Table 1-2.
Description
Use the display qos-interface traffic-limit command to display the traffic policing
configuration of a port or a unit.
Related commands: traffic-limit.
Examples
# Display the traffic policing configuration of Ethernet 1/0/1.
<Sysname> display qos-interface Ethernet1/0/1 traffic-limit
Ethernet1/0/1: traffic-limit
Inbound:
Matches: Acl 3000 rule 1 running
Effect mode: Union effect
Egress port: Ethernet1/0/2
Target rate: 640 Kbps
Burst bucket size: 16 Kbyte
Exceed action: remark-dscp cs7
Refer to Table 1-3 for the description on the output fields.
display qos-interface traffic-priority
Syntax
display qos-interface { interface-type interface-number | unit-id } traffic-priority
To Next Page
Loading...
