2-5
Parameters
profile-name: QoS profile name, a case-insensitive string of 1 to 32 characters, starting with an English
letter in the range a to z and A to Z. Note that a QoS profile name cannot be all, interface, user, undo,
or name.
Description
Use the qos-profile command to create a QoS profile and enter QoS profile view. If the QoS profile
already exists, this command leads you to the corresponding QoS profile view.
Use the undo qos-profile command to remove a QoS profile.
To remove or modify a QoS profile already applied to a port, you must remove the QoS profile from the
port first.
z If the QoS profile is applied to the port manually, use the undo apply qos-profile command to
remove the QoS profile from the port.
z If the QoS profile is applied to the port dynamically, log off the user connected to the port to remove
the QoS profile from the port.
Examples
# Create a QoS profile named a123.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] qos-profile a123
[Sysname-qos-profile-a123]
qos-profile port-based
Syntax
qos-profile port-based
undo qos-profile port-based
View
Ethernet port view
Parameters
None
Description
Use the qos-profile port-based command to configure the QoS profile application mode on a port to
be port-based.
Use the undo qos-profile port-based command to restore the default.
By default, the application mode of a QoS profile is user-based.
Note that:
To Next Page
Loading...
