2-13
Table 2-6 Description on the fields of the display tcp status command
Field Description
*
If there is an asterisk before a connection, it
means that the TCP connection is authenticated
through the MD5 algorithm.
TCPCB TCP control block
Local Add:port Local IP address and port number
Foreign Add:port Remote IP address and port number
State State of the TCP connection
display udp statistics
Syntax
display udp statistics
View
Any view
Parameters
None
Description
Use the display udp statistics command to display the statistics about UDP packets.
Related commands: reset udp statistics.
Examples
# Display the statistics about UDP packets.
<Sysname> display udp statistics
Received packets:
Total: 26320
checksum error: 0
shorter than header: 0, data length larger than packet: 0
no socket on port: 0
total broadcast or multicast packets : 25006
no socket broadcast or multicast packets: 24989
not delivered, input socket full: 0
input packets missing pcb cache: 1314
Sent packets:
Total: 7187
Table 2-7 Description on the fields of the display udp statistics command
Field Description
Received
Total Total number of received UDP packets
To Next Page
Loading...
