3Com 5500-EI PWR - Remote-Ping Server Commands; Remote-Ping-Server Enable

1-39
z To perform an FTP test successfully, the configured username must be consistent with the
username configured on the FTP server.
z This command applies to FTP tests only.
Examples
# Configure the username for logging into the FTP server in an FTP test as administrator.
<Sysname> system-view
System View: return to User View with Ctrl+Z
[Sysname] remote-ping administrator ftp
[Sysname-remote-ping-administrator-ftp] test-type ftp
[Sysname-remote-ping-administrator-ftp] username administrator
remote-ping Server Commands
z A remote-ping server is required for only jitter, TCP, and UDP tests.
z You are not recommended to configure remote-ping jitter/UDP/TCP servers on ports 1 through
1023 (well-known ports); otherwise, remote-ping probes may fail or the services corresponding to
these ports may be unavailable.
remote-ping-server enable
Syntax
remote-ping-server enable
undo remote-ping-server enable
View
System view
Parameters
None
Description
Use the remote-ping-server enable command to enable the remote-ping server function.
Use the undo remote-ping-server enable command to disable the remote-ping server function.
By default, the remote-ping server function is disabled.