3Com 5500-EI PWR - 1 Common Multicast Configuration Commands; Display Mac-Address Multicast Static

1-1
1 Common Multicast Configuration Commands
Common Multicast Configuration Commands
display mac-address multicast static
Syntax
display mac-address multicast static [ [ mac-address ] vlan vlan-id ] [ count ]
View
Any view
Parameters
mac-address: Displays the static multicast MAC entry information for the specified MAC address.
Without this argument provided, this command displays the information of all static multicast MAC
entries in the specified VLAN.
vlan vlan-id: Displays the static multicast MAC entry information in the specified VLAN. Without a VLAN
specified, this command displays the static multicast MAC entry information in all VLANs.
count: Displays the number of static multicast MAC entries.
Description
Use the display mac-address multicast static command to display the information about the
multicast MAC address entry or entries manually configured on the switch.
Related commands: mac-address multicast interface, mac-address multicast vlan.
Examples
# Display the information of all static multicast MAC entries in VLAN 1.
<Sysname> display mac-address multicast static vlan 1
MAC ADDR VLAN ID STATE PORT INDEX AGING TIME(s)
0100-0001-0001 1 Config static Ethernet1/0/1 NOAGED
Ethernet1/0/2
Ethernet1/0/3
Ethernet1/0/4
--- 1 static mac address(es) found ---
Table 1-1 display mac-address multicast static command output description
Field Description
MAC ADDR MAC address
VLAN ID
The VLAN in which the MAC address is
manually added