3Com 5500-EI PWR - Habp Server Vlan; Habp Timer

3-4
habp server vlan
Syntax
habp server vlan vlan-id
undo habp server
View
System view
Parameters
vlan-id: VLAN ID, ranging from 1 to 4094.
Description
Use the habp server vlan command to configure a switch to operate as an HABP server. This
command also specifies the VLAN where HABP packets are broadcast.
Use the undo habp server vlan command to revert to the default HABP mode.
By default, a switch operates as an HABP client.
To specify a switch to operate as an HABP server, you need to enable HABP (using the habp enable
command) for the switch first. When HABP is not enabled, the habp server vlan command cannot take
effect.
Examples
# Specify the switch to operate as an HABP server and the HABP packets to be broadcast in VLAN 2.
(Assume that HABP is enabled.)
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] habp server vlan 2
habp timer
Syntax
habp timer interval
undo habp timer
View
System view
Parameters
interval: Interval (in seconds) to send HABP request packets. This argument ranges from 5 to 600.
Description
Use the habp timer command to set the interval for a switch to send HABP request packets.
Use the undo habp timer command to revert to the default interval.
The default interval for a switch to send HABP request packets is 20 seconds.
Use these two commands on switches operating as HABP servers only.