1-7
interface-type: Interface type.
interface-number: Interface number.
module-name: Functional module name.
fabric: Specifies to display the enabled debugging of the switches in the Fabric.
by-module: Specifies to display fabric debugging by module.
Description
Use the display debugging command to display enabled debugging on a specified device or the whole
Fabric.
Examples
# Display enabled debugging on unit 1.
<Sysname> display debugging unit 1
IP icmp debugging is on
Rip packet debugging switch is on
Rip receive debugging switch is on
Rip send debugging switch is on
display version
Syntax
display version
View
Any view
Parameters
None
Description
Use the display version command to display the version information about the switch system.
Specifically, you can use this command to check the software version and release time, the basic
hardware configuration, and some other information about the switch.
Examples
# Display the version information of the system.
<Sysname> display version
3Com Corporation
Switch 5500-EI Software Version 3Com OS V3.03.02s56e
Copyright (c) 2004-2008 3Com Corporation and its licensors, All rights reserved.
Switch 5500-EI uptime is 0 week, 0 day, 0 hour, 26 minutes
Switch 5500-EI 52-Port with 1 Processor
64M bytes DRAM
16384K bytes Flash Memory
Config Register points to FLASH
CPLD Version is CPLD 001
To Next Page
Loading...
