1-13
Examples
# Create detected group 10 and specify to detect the IP address of 202.12.1.55.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] detect-group 10
[Sysname-detect-group-10] detect-list 1 ip address 202.12.1.55
# Specify to decrease the priority of the master of VRRP group 1 by 20 when detected group 10 is
unreachable.
[Sysname] interface vlan-interface 2
[Sysname- Vlan-interface2] vrrp vrid 1 track detect-group 10 reduced 20
vrrp vrid virtual-ip
Syntax
vrrp vrid virtual-router-id virtual-ip virtual-address
undo vrrp vrid virtual-router-id [ virtual-ip virtual-address ]
View
VLAN interface view
Parameters
virtual-router-id: VRRP group ID, ranging from 1 to 255.
virtual-address: Virtual IP address to be configured.
Description
Use the vrrp vrid virtual-ip command to create a VRRP group and configure the virtual IP address for
the VRRP group, or add a virtual IP address to the virtual IP address list of an existing VRRP group. You
can add up to 16 virtual IP addresses for a VRRP group.
Use the undo vrrp vrid virtual-ip command to remove an existing VRRP group, or remove a virtual IP
address from the virtual IP address list of an existing VRRP group. A VRRP group is removed if all its
virtual IP addresses are removed.
By default, no VRRP group is created.
Note that:
z A virtual IP address cannot be an all-zero address (0.0.0.0), a broadcast address
(255.255.255.255), a loopback interface, a non-A/B/C class address, or an illegal IP address, such
as 0.0.0.1.
z Virtual IP addresses of a VRRP group must be in the same network segment with the IP address of
the interface where the VRRP group is configured. Otherwise, the VRRP group cannot work
normally.
To Next Page
Loading...
