1-6
reset smart-link packets counter
Syntax
reset smart-link packets counter
View
User view
Parameters
None
Description
Use the reset smart-link packets counter command to clear the flush message statistics of Smart
Link.
Examples
# Clear the flush message statistics of Smart Link.
<Sysname> reset smart-link packets counter
smart-link flush enable
Syntax
z In Ethernet port view:
smart-link flush enable control-vlan vlan-id
undo smart-link flush enable
z In system view:
smart-link flush enable control-vlan vlan-id port interface-type interface-number [ to interface-type
interface-number ]
undo smart-link flush enable port interface-type interface-number [ to interface-type
interface-number ]
View
Ethernet port view, system view
Parameters
vlan-id: Control VLAN ID, in the range of 1 to 4,094.
Description
Use the smart-link flush enable control-vlan command to enable the current/specified port to
process flush messages received on the specified control VLAN.
Use the undo smart-link flush enable command to disable the port from processing flush messages.
z The command executed in Ethernet port view has effect on the current port only.
z The command executed in system view has effect on the specified port only.
By default, no control VLAN is specified.
If you configure different control VLANs on the same port, only the last one takes effect.
To Next Page
Loading...
