3Com 5500-EI PWR - Lldp Admin-Status

1-15
Capabilities TLV YES YES
Network Policy TLV YES YES
Location Identification TLV NO NO
Extended Power via MDI TLV YES YES
Inventory TLV YES YES
Table 1-5 display lldp tlv-config command output description
Field Description
LLDP tlv-config of port number
interface-type interface-number
TLVs that are currently sent through a port
NAME TLV type
STATUS
Indicates whether or not TLVs of a specific type are
currently sent through a port
DEFAULT
Indicates whether or not TLVs of a specific type are sent
through a port by default
Basic optional TLV
Basic TLVs, including:
z Port description TLV
z System name TLV
z System description TLV
z System capabilities TLV
z Management address TLV
IEEE 802.1 extended TLV
IEEE 802.1 extended TLVs, including:
z Port VLAN ID TLV
z Port and protocol VLAN ID TLV
z VLAN name TLV
IEEE 802.3 extended TLV
IEEE 802.3 extended TLVs, including:
z MAC-Physic TLV
z Power via MDI TLV
z Link aggregation TLV
z Maximum frame size TLV
LLDP-MED extend TLV
MED related LLDP TLVs, including:
z Capabilities TLV
z Network Policy TLV
z Extended Power-via-MDI TLV
z Location Identification TLV
z Inventory TLV, which can be hardware revision TLV,
firmware revision TLV, software revision TLV, serial
number TLV, manufacturer name TLV, model name
TLV, and asset id TLV.
lldp admin-status
Syntax
lldp admin-status { disable | rx | tx | txrx }
undo lldp admin-status
View
Ethernet interface view