1-25
traffic-limit
Syntax
traffic-limit inbound acl-rule [ union-effect ] [ egress-port interface-type
interface-number ] target-rate [ burst-bucket burst-bucket-size ] [ exceed action ]
undo traffic-limit inbound acl-rule
View
Ethernet port view
Parameters
inbound: Imposes traffic limit on the packets received through the interface.
acl-rule: ACL rules to be applied for traffic classification. This argument can be the
combination of multiple ACLs. For more information about this argument, refer to
Table 1-4
and
Table 1-5. Note that the ACL rules referenced must be those defined with the permit
keyword.
union-effect: Specifies that all the ACL rules, including those identified by the acl-rule
argument in this command and those applied previously, are valid. If this keyword is not
specified, traffic policing issues both the rate limiting action and the permit action at the
same time, that is, traffic policing permits the conforming traffic to pass through. If this
keyword is specified, traffic policing issues only the rate limiting action but not the permit
action. In this case, if a packet matches both an ACL rule specified in the traffic-limit
command and another previously applied ACL rule with the deny keyword specified, the
packet will be dropped.
To Next Page
Loading...
