3Com 5500-EI PWR - Display Pim Routing-Table

3-7
display pim routing-table
Syntax
display pim routing-table [ { { *g [ group-address [ mask { mask-length | mask } ] ] | **rp [ rp-address
[ mask { mask-length | mask } ] ] } | { group-address [ mask { mask-length | mask } ] | source-address
[ mask { mask-length | mask } ] } * } | incoming-interface interface-type interface-number |
{ dense-mode | sparse-mode } ] *
View
Any view
Parameters
*g: Specifies a (*, G) entry.
**rp: Specifies a (*, *, RP) route entry.
rp-address: RP address.
group-address: Multicast group address, in the range of 224.0.0.0 to 239.255.255.255.
source-address: Multicast source address.
mask: Mask of the multicast group address, multicast source address, or RP address, 255.255.255.255
by default.
mask-length: Mask length of the multicast group address, multicast source address, or RP address, in
the range of 0 to 32. The system default is 32.
incoming-interface: Displays multicast routing entries containing the specified incoming interface.
interface-type interface-number: Specifies an interface by its type and number. If you specify null, the
command displays the multicast routing entries without an incoming interface.
dense-mode: Displays PIM-DM multicast routing information.
sparse-mode: Displays PIM-SM multicast routing information.
Description
Use the display pim routing-table command to display information about the PIM multicast routing
table.
The displayed information includes the SPT information and RPF information.
Examples
# Display the information about the PIM multicast routing table.
<Sysname> display pim routing-table
PIM-SM Routing Table
Total 1 (S,G) entry, 1 (*,G) entry, 0 (*,*,RP) entry
(*, 228.0.0.0), RP 23.12.0.1
Protocol 0x20: PIMSM, Flag 0x3: RPT WC
Uptime: 00:00:13, Timeout in 197 sec
Upstream interface: Vlan-interface1, RPF neighbor: 200.1.0.1
Downstream interface list:
Vlan-interface401, Protocol 0x100: RPT, timeout in 197 sec