3Com 5500-EI PWR - Port Trunk Pvid Vlan; Protocol-Based VLAN Configuration Commands; Display Protocol-Vlan Interface

1-12
Please wait... Done.
port trunk pvid vlan
Syntax
port trunk pvid vlan vlan-id
undo port trunk pvid
View
Ethernet port view
Parameters
vlan-id: VLAN ID defined in IEEE802.1Q, in the range of 1 to 4094. It is 1 by default.
Description
Use the port trunk pvid vlan command to set the default VLAN ID for the trunk port.
Use the undo port trunk pvid command to restore the default.
To guarantee the proper packet transmission, the default VLAN ID of the local trunk port must be
identical with that of the trunk port on the peer switch connected with the local trunk port.
Related commands: port link-type.
Examples
# Set the default VLAN ID of the trunk port GigabitEthernet 1/0/1 to 100.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] interface GigabitEthernet 1/0/1
[Sysname-GigabitEthernet1/0/1] port link-type trunk
[Sysname-GigabitEthernet1/0/1] port trunk pvid vlan 100
Protocol-Based VLAN Configuration Commands
display protocol-vlan interface
Syntax
display protocol-vlan interface { interface-type interface-number [ to interface-type interface-number ]
| all }
View
Any view
Parameter
interface-type interface-number [ to interface-type interface-number ]: Specifies the port on which
protocol-based VLAN configuration information is displayed. If you do not use the to keyword, only one
port is specified. If you use the to keyword, a range of ports are specified. The port number after to must
be greater than or equal to that before to. The interface-type argument refers to the port type and the
interface-number argument refers to the port number.