3Com 5500-EI PWR - Display Protocol-Priority

1-2
Examples
# Enable the burst function.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] burst-mode enable
display protocol-priority
Syntax
display protocol-priority
View
Any view
Parameters
None
Description
Use the display protocol-priority command to display the list of protocol priorities you
assigned with the protocol-priority command.
A Switch 5500-EI supports setting priorities for certain protocol packets generated by it.
The supported protocols are Telnet, SNMP, ICMP, and OSPF. Depending on your
configuration, the IP or DSCP precedence is displayed for a specified protocol.
Related commands: protocol-priority.
Examples
# Display the list of protocol priorities manually specified.
<Sysname> display protocol-priority
Protocol: ospf
IP-Precedence: routine(0)
Protocol: telnet
DSCP: be(0)
Table 1-1 Description on the fields of the display protocol-priority command
Field Description
Protocol: ospf
Indicate that a priority has been set for
OSPF packets with the protocol-priority
command.