1-6
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] vrrp method real-mac
vrrp ping-enable
Syntax
vrrp ping-enable
undo vrrp ping-enable
View
System view
Parameters
None
Description
Use the vrrp ping-enable command to enable a VRRP group to respond to ping packets destined for
its virtual router IP address.
Use the undo vrrp ping-enable command to restore the default.
By default, a VRRP group does not respond to ping packets destined for its virtual router IP address.
Note that this command must be configured before any VRRP group is created. If a VRRP group
already exists on the switch, you are not allowed to execute the command.
Examples
# Enable a VRRP group to respond to ping packets destined for its virtual router IP address.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] vrrp ping-enable
vrrp vlan-interface vrid track
Syntax
vrrp vlan-interface vlan-id vrid virtual-router-id track [ reduced value-reduced ]
undo vrrp vlan-interface vlan-id vrid virtual-router-id track
View
Ethernet port view
Parameters
virtual-router-id: VRRP group ID, ranging from 1 to 255.
vlan-id: VLAN ID.
value-reduced: Value by which the priority of a switch is to decrease. This argument ranges from 1 to
255, and defaults to 10.
To Next Page
Loading...
