1-9
SNMPv3
display snmp-agent trap-list
Syntax
display snmp-agent trap-list
View
Any view
Parameters
None
Description
Use the display snmp-agent trap-list command to display the modules that can generate traps and
whether the sending of traps is enabled on the modules.
If a module contains multiple submodules, the trap function of the entire module is displayed as enabled
as long as the trap function of any of the submodules is enabled.
Related commands: snmp-agent trap enable.
Examples
# Display the modules that can generate traps and whether the trap function is enabled on the modules.
<Sysname> display snmp-agent trap-list
configuration trap enable
flash trap enable
ospf trap enable
standard trap enable
system trap enable
vrrp trap enable
Enable traps :6; Disable traps 0
In the above output information, enable indicates that traps are allowed to be generated on the module,
and disable indicates that traps are not allowed to be generated on the module.
By default, the modules that can generate traps are allowed to generate traps. If you do not need traps
of some modules, you can use the undo snmp-agent trap enable command to disable the trap
function of the specific modules.
display snmp-agent usm-user
Syntax
display snmp-agent usm-user [ engineid engineid | username user-name | group group-name ]*
View
Any view
To Next Page
Loading...
