1-10
[Sysname-ui-aux0] display this
#
user-interface aux 0 4
idle-timeout 0 0
user-interface aux 5 7
user-interface vty 0
authentication-mode none
user privilege level 3
set authentication password simple 123
idle-timeout 0 0
user-interface vty 1 4
authentication-mode none
user privilege level 3
set authentication password simple 1
idle-timeout 0 0
#
return
reset saved-configuration
Syntax
reset saved-configuration [ backup | main ]
View
User view
Parameters
backup: Erases the backup configuration file.
main: Erases the main configuration file.
Description
Use the reset saved-configuration command to erase the configuration file saved in the Flash of a
switch.
The following two situations exist:
z While the reset saved-configuration [ main ] command erases the configuration file with main
attribute, it only erases the main attribute of a configuration file having both main and backup
attribute.
z While the reset saved-configuration backup command erases the configuration file with backup
attribute, it only erases the backup attribute of a configuration file having both main and backup
attribute.
You may need to erase the configuration file for one of these reasons:
z After you upgrade software, the old configuration file does not match the new software.
z The startup configuration file is corrupted or not the one you need.
To Next Page
Loading...
