1-7
Examples
# Display the test results of the test group with administrator name administrator, and operation tag
icmp.
<Sysname> display remote-ping results administrator icmp
remote-ping entry(admin administrator, tag icmp) test result:
Destination ip address:10.2.2.2
Send operation times: 10 Receive response times: 10
Min/Max/Average Round Trip Time: 1/2/1
Square-Sum of Round Trip Time: 13
Last succeeded test time: 2004-11-25 16:28:55.0
Extend result:
SD Maximal delay: 0 DS Maximal delay: 0
Packet lost in test: 0%
Disconnect operation number: 0 Operation timeout number: 0
System busy operation number: 0 Connection fail number: 0
Operation sequence errors: 0 Drop operation number: 0
Other operation errors: 0
Table 1-2 Description on the fields of the display remote-ping result command
Field Description
Destination ip address Destination IP address
Send operation times Number of probes made
Receive response times Number of received response packets
Min/Max/Average Round Trip Time
Minimum/maximum/average roundtrip time, in
milliseconds
Square-Sum of Round Trip Time Square sum of roundtrip time
Last succeeded test time Completion time of the last successful test
SD Maximal delay
Maximum delay from the source to the
destination
DS Maximal delay
Maximum delay from the destination to the
source
Packet lost in test Average packet loss ratio
Disconnect operation number
Number of times the test was disconnected by
the remote end
System busy operation number
Number of times the test failed because the
system was busy
Operation sequence errors Number of out-of-sequence packets received
Other operation errors Number of other errors
Operation timeout number Number of time-out occurrences in a test
Connection fail number
Number of failures to connect with the remote
end
Drop operation number Number of system resource allocation failures
To Next Page
Loading...
