1-13
Parameters
administrator-name: Name of the administrator creating the test.
operation-tag: Test operation tag.
Description
Use the display remote-ping statistics command to display test statistics.
After a test begins, if all the probes in the first test have not been finished, when you use the command
to view statistics, all statistics results will be 0.
Examples
# Display the statistics information for admin jitter test group, the test type of which is jitter.
<Sysname> display remote-ping statistics admin jitter
remote-ping entry(admin admin, tag jitter) statistics record:
No. : 1
Destination ip address: 169.254.10.3
StartTime: 2000/1 /2 3 :12:44
LifeTime: 21
Send operation times: 0 Receive response times: 0
Max Round Trip Time: 0 Min Round Trip Time: 0
Sum Round Trip Time: 0 Average Round Trip Time: 0
Square-Sum of Round Trip Time: 0 Packet lost in test: 0%
Disconnect operation number: 0 Operation timeout number: 0
System busy operation number:0 Connection fail number: 0
Operation sequence errors: 0 Drop operation number: 0
Other operation errors: 0
Jitter result:
Min Positive SD:0 Min Positive DS:0
Max Positive SD:0 Max Positive DS:0
Positive SD Number:0 Positive DS Number:0
Positive SD Sum:0 Positive DS Sum:0
Positive SD average:0 Positive DS average:0
Positive SD Square Sum:0 Positive DS Square Sum:0
Min Negative SD:0 Min Negative DS:0
Max Negative SD:0 Max Negative DS:0
Negative SD Number:0 Negative DS Number:0
Negative SD Sum:0 Negative DS Sum: 0
Negative SD average:0 Negative DS average:0
Negative SD Square Sum:0 Negative DS Square Sum:0
SD lost packets number:0 DS lost packet number:0
SD packet lost in test:0% DS packet lost in test:0%
Unknown result lost packet number:0
Table 1-7 Description on fields in the output of the display remote-ping statistic command
Field Description
Start time The time when a test starts
To Next Page
Loading...
