1-41
View
System view
Parameters
ip-address: IP address from which a remote-ping server performs UDP listening.
port-number: Port from which a remote-ping server performs UDP listening. The value ranges from 1 to
49999. In is not recommended to use some special ports (that is, those used for fixed functions, such as
port 1701). Otherwise, the remote-ping test may fail.
Description
Use the remote-ping-server udpecho command to enable UDP listening on a remote-ping server.
Use the undo remote-ping-server udpecho command to disable UDP listening.
When performing a jitter test or a UDP connection test on a specified port of a remote-ping client, you
must enable UDP listening on the server if an switch serves as a remote-ping server; otherwise, the test
may fail.
Related commands: remote-ping-server enable.
Examples
# Enable UDP listening, using 169.254.10.3 as the IP address and 9000 as the port number.
<Sysname> system-view
System View: return to User View with Ctrl+Z
[Sysname] remote-ping-server udpecho 169.254.10.3 9000
To Next Page
Loading...
