1-44
View
Any view
Parameters
mac-address: MAC address of the device whose detailed information is to be displayed.
Description
Use the display ntdp single-device mac-address command to display the detailed information, which
is collected through NTDP protocol packets, about a single device. The information displayed by the
command is similar to that displayed by the display cluster members command. However, if you want
to display information about a device that is enabled with only NTDP and is not in any cluster, you have
to use the display ntdp single-device mac-address command.
Examples
# Display the detailed information about the switch with the MAC address 000f-e200-3956.
<Sysname> display ntdp single-device mac-address 000f-e200-3956
Hostname : 3Com
MAC : 000f-e200-3956
Hop : 0
Platform : Switch 5500-EI
IP :
Version:
3Com Corporation
Switch 5500-EI Software Version 3Com OS V3.03.02s56e
Copyright (c) 2004-2008 3Com Corporation and its licensors, All rights reserved.
Switch 5500-EI 28-Port Switch 5500-EI V3.03.02s56e
Cluster : Candidate switch
Peer MAC Peer Port ID Native Port ID Speed Duplex
000f-e239-1333 Ethernet1/0/4 Ethernet1/0/10 100 FULL
Table 1-12 Description on the fields of the display ntdp single-device command
Field Description
Hostname System name of a device
MAC MAC address of the device
Hop
Number of hops from the device to the topology-collecting
device
Platform Platform information of the device
IP
IP address and mask length of the management VLAN
interface of the device
Version Version information
Cluster Role the device plays in the cluster
Peer MAC MAC address of the peer device
To Next Page
Loading...
