CELL-DYN 3000 System Operator’s Manual 5-99
9140240E — May 1995
Chapter 5 Operating Instructions
9.If necessary, press [CHANGE SAMPLER] to select the desired
mode.
10.Run the well-mixed samples in the order in which the information
was entered in the Work List.
NOTE: If desired, samples may be run with the WORK LIST
Screen displayed. Modifications to the Work List should be made
only when the Data Station is in the READY state.
Running STAT Samples
Turn the Work List OFF before running a STAT sample. When the STAT
sample run is completed, turn the Work List ON and continue to process
samples in the order in which they were entered in the Work List.
To Next Page
Loading...
