6-16 CELL-DYN 3000 System Operator’s Manual
9140240E — May 1995
Calibration Chapter 6
The [RESET ALL TO 1.00] key is used to reset all of the calibration
factors to 1.00.
The [RETURN] key is used to return to the CALIBRATION MENU
Screen.
The [CALIBRATN LOG] key is used to display the CALIBRATION
LOG Screen (Figure 6.4) for the Open or Closed mode. The following
soft key labels are displayed when the [CALIBRATN LOG] key is
pressed:
OPEN SAMPLER or
CLOSED SAMPLER (Key label alternates between
these two selections)
PRINT LOG
RETURN
The [OPEN SAMPLER/CLOSED SAMPLER] key is used to display
the calibration log for the selected mode.
NOTE: The key is labeled for the sampler mode that is NOT
currently displayed.
The [PRINT LOG] key is used to print the Calibration Log for the
displayed mode.
The [RETURN] key is used to return to the CALIBRATION MENU
Screen.
The [AUTO-CALIBRATE] key is used to access the Auto-Calibration
program. The AUTO-CALIBRATION Screen (Figure 6.5) and the
following soft key labels are displayed:
WHOLE BLOOD
CALIBRATR
LATEX
CHANGE SAMPLER
RETURN
RESET
ALL TO 1.00
RETURN
CALIBRATN
LOG
OPEN
SAMPLER
PRINT
LOG
RETURN
AUTO-
CALIBRATE
To Next Page
Loading...
