10-56 CELL-DYN 3000 System Operator’s Manual
9140240E — May 1995
Troubleshooting Chapter 10
Table 10.2 General Fault Conditions (Continued)
Printer (Graphics or Ticket) Unavailable/SB
––– -Probable Cause–––– ––– -Corrective Action––––
1. The print buffer (the 1. Press the [STOP PRINTING]
memory area where the key followed by the
material is stored while [CONFIRM STOP] key on
awaiting printing) is full. the CUSTOMIZE
PRINTED REPORT Screen
for the appropriate printer.
2. The printer is turned OFF. 2. Turn the printer power
switch ON.
3. The printer is not on-line. 3. Check that the printer
“on-line” indicator is
illuminated. If necessary,
refer to the printer manual
for assistance.
4. The printer is disconnected 4. Check the printer cable
or the connection is loose. connection on the back of
the Data Station and on the
back of the printer. If
necessary, secure the
connections. Press [PRINT
REPORT]. If the message is
still displayed, turn the
printer power switch OFF
and ON to reset the printer.
To Next Page
Loading...
