11-4 CELL-DYN 3000 System Operator’s Manual
9140240E — May 1995
Printer Chapter 11
7. Pull the bail lever forward. The ticket will automatically feed into
place. Release the paper bail lever.
8. Be sure the printer is deselected (SEL indicator is not illuminated)
and set the top of form by pressing and holding the TOF/QUIET
key and pressing the FORM FEED key to move the ticket up or
pressing the LINE FEED key to move the ticket down. (The ticket
moves in very fine increments so it can be precisely positioned.)
NOTE: The ticket will only move down to a certain point to
prevent potential ticket jams. Do not move the top of the ticket
below the paper bail.
9. Position the ticket so that the lower red line on the paper shield
(located between the print head and the paper) is positioned where
the first line of printing should occur.
NOTE: When the top of form is set, the position is retained in
the printer memory until it is reset.
10. Press the SEL key to select the printer. The printer is now ready to
print.
To Next Page
Loading...
