ADCMT 6240B - Setting GPIB

6240B DC Voltage Current Source/Monitor Operation Manual
6.3.3 Setting GPIB
6-7
6.3.3 Setting GPIB
These settings are enabled when the GPIB interface is selected.
• Setting the address
• Setting Talk Only
Operation Character display area
1.
Press MENU and select L) I/F with or .
L) I/F
2.
Enter the Select level with .
1) I/F BUS
GPIB
3.
Select 2) GPIB Adr with or .
(Currently set address)
2) GPIB Adr
01
4.
Enter the Input/Run level with .
2) GPIB Adr
01
5.
To set the address, press or to select the
digit to be changed and use to increase or
decrease the figure. Alternatively, directly enter the
address pressing the 123... key.
2) GPIB Adr
17
6. Press Exit to exit the menu.
Operation Character display area
1.
Press MENU and select L) I/F with or .
L) I/F
2.
Enter the Select level with .
1) I/F BUS
GPIB
3.
Select 4) Talk Only with or .
4) Talk Only
Off
4.
Enter the Input/Run level with .
4) Talk Only
Off
5.
Select Talk Only ON or OFF with .
4) Talk Only
ON
6. Press Exit to exit the menu.