6240B DC Voltage Current Source/Monitor Operation Manual
1.4.1 Environmental Conditions
1-6
Figure 1-2 Operating Environment
NOTE: Warm-up Time
Allow the 6240B to warm up for at least 60 minutes after turning on the power to ensure the specified
accuracy of the 6240B.
Vibration
Direct sunlight
Corrosive
gas
Front
• Avoid operation in these areas.
• Use a noise-cut filter when there is a large amount
of noise riding on the power line.
Dust
• Keep the rear panel more than 10 centimeters away
from the wall
Front
• Do not position the 6240B in a position with
the rear panel facing down.
Line Filter
To Next Page
Loading...
