ADCMT 6240B - Setting USB ID

6240B DC Voltage Current Source/Monitor Operation Manual
6.4.3 Setting Up USB
6-9
6.4.3.2 Setting USB ID
These settings are enabled when the USB interface is selected.
6.4.3.3 Precautions when Using USB
When running a query command, leave a 20 ms wait time after the previous command.
Operation Character display area
1.
Press MENU and select L) I/F with or .
L) I/F
2.
Enter the Select level with .
1) I/F BUS
USB
3.
Select 2) USB Id with or .
(Currently set ID)
2) USB Id
001
4.
Enter the Input/Run level with .
2) USB Id
002
5.
To set the ID, press or to select the digit to
be changed and use to increase or decrease the
figure. Alternatively, directly enter the ID pressing
the 123... key.
6. Press Exit to exit the menu.