6240B DC Voltage Current Source/Monitor Operation Manual
2.2.1 Setting Source Value
2-19
2. Press 3, ., and 1 in this order.
While inputting figures, the cursor blinks.
3. Press ENTER.
The numeric value has been applied and the direct input mode is released.
4. Press 123…, 1, 0, and ENTER keys in order to set +10 V.
• When the FIT indicator turns OFF, the value exceeds the 3 V setting range
and an error occurs. The value cannot be set.
• When the FIT indicator turns ON, the optimum 15 V range is set.
To Next Page
Loading...
